It is a fantastic feeling to create something by hand, to build a working device from tiny components, using manual tools only. From soldering the PCB through measuring individual components and finally closing the packaging, every stage is carried out in-house, with manual labour.
Our technicians have incredible knowledge and experience in how to build a product to be flawless and beautiful. Below, we briefly discuss the most important stages in the birth of an amplifier.
Every single through-hole component – and many surface mounted as well – is populated by hand, then soldered with tin wire and a soldering iron.
Our highly qualified colleagues have decades of experience in this field, so they can perform this task with excellent precision.
Before powder coating, we inspect the metalwork and correct any imperfections. After surface treatment, we cut threads and expose the necessary metallic contacts.
We assemble the more complex front panels, and populate the back panels with connectors.
The interior wires must be cut to the exact length, stripped, then dip tinned or crimped with a connector.
There are numerous components that we sort based on our strict criteria. We pay particular attention to the blue Alps Velvet potentiometers we use in most of our devices. With a custom test rig, we check and hand adjust each of them for a perfect channel balance.
There are several blocks in an amplifier, many of which we turn into modules. We can check their proper functioning easier this way. We do not compromise here; we only cook with perfect ingredients, and any flaws that may arise are corrected.
After installing the confectioned wires, we prepare the modules for measurement.
Most modules can be tested independently – in the appropriate custom test device. We inspect the modules visually, then switch them on for the first time.
Using various laboratory equipment, we check their operation and set the initial variables. Firmwares are loaded at this point, the quiescent currents are checked here first, and this is where the amplifiers encounter an audio signal for the first time.

The device is now self-propelled and operates from its own power supply. At this point, we perform high-current measurements and fine adjustments.
We retest all functions and repeat all measurements we already performed, when the device was in module state. Then we do load measurements and check compliance with specifications. We also carry out a few stress tests to see how the device handles these situations.
We run-in all our amplifiers at high load for varying periods of time, depending on the device. During this test the amplifier heats up significantly, the semiconductors get their neccessary burn-in, and the capacitors receive their initial formatting pattern.
At the same time, we check the measurable values, and constantly monitor the output with an analog oscilloscope. If there is any minor fault with the amplifier, it is revealed here.
Our Transcap amplifiers have sensitive balance settings, and the preset values change during heat-up. We adjust our amps to deliver maximum performance when listening to music. This requires an initial break-in period as well as the device to be at the correct operating temperature.
We make the last fine adjustments under these operating conditions. It illustrates perfectly how precise the adjustments need to be, as closing the chassis with its top cover can change some values.

Our amplifiers travel across the globe, and we need to protect them from harm with sturdy packaging.
We use environmentally friendly solutions as much as possible, partially recycled materials, and little ink only for minimalist graphics. We feel that the health of Nature is more important than fancy packaging. The cardboard boxes are strong and can be reused for other purposes, while the rest can be recycled easily.
